Odd cycling, a tripping breaker, or a blinking error code deserves an actual diagnosis, not a guess. We test capacitors, contactors, and refrigerant pressure before recommending a single part, on every Tenaha call.
Most calls we get for Hvac Repair trace back to a short list of failure points — a weak capacitor, a pitted contactor, a control board acting erratically. A proper meter check separates a cheap fix from an unnecessary expensive one, and we'd rather find the $150 answer.
Standards that hold on every call, no exceptions.
Every tech carries a current license, EPA 608 refrigerant certification, and liability coverage — we don't outsource this work.
Because we stage trucks close to Tenaha, most calls land a same-day or next-morning window instead of a week-long wait.
The number we quote is the number on the invoice, agreed to upfront.
Every truck carries manifold gauges, amp clamps, and combustion analyzers, so the fault gets measured, not assumed.
Six of the most common jobs our Tenaha techs handle.
The first move is isolating exactly which of these failed: capacitor, contactor, thermostat call, or charge level.
A failed run capacitor is behind a huge share of no-start calls, and it's confirmed with a microfarad reading, not a guess, and we confirm it with an actual meter reading before replacing anything.
High amp draw or a seized bearing on the blower motor shows up as weak airflow or a burning smell, and we test the windings before recommending replacement.
What looks like a major failure is sometimes a $200 control issue, and we rule these out before quoting anything larger.
We locate the real leak, because a top-off without finding the source only buys a few weeks.
Ignitor resistance, flame sensor microamp signal, and gas valve response all get tested before a furnace gets condemned, since a dirty flame sensor is a five-minute fix, not a new furnace.
What happens once you dial in.
Tell us what's happening and we'll get a tech moving — no phone tree to navigate.
A stocked truck arrives within your confirmed window — not a vague all-day estimate.
Full diagnostic first, flat-rate quote second, your approval before we touch anything.
Same-visit completion in most cases, covered by our warranty.
Straight from completed service calls.
Breaker kept popping every time the blower kicked on. Turned out to be a shorted wire nobody had caught in two prior visits from other companies.
— N. Okafor, homeowner
Appreciated getting a text with a two-hour window instead of the usual 'sometime this afternoon.' Tech was right on time.
— V. Delgado, property manager
System was cycling on and off every few minutes. They traced it to a thermostat wiring issue, not the compressor everyone assumed it was.
— L. Whitfield, homeowner
Third HVAC company we've tried for our small office building. First one to actually pull a service history instead of starting from zero each visit.
— C. Abernathy, office manager
What Tenaha customers ask most.
Same-day service is typical, next-morning as a fallback, and dispatch texts you once the tech is moving.
Yes, but it's a known number before anyone shows up, and it comes off the final bill if you go ahead with the repair, and it's subtracted once you approve the fix.
We diagnose first and explain the actual cause before quoting — no billing for guesswork, so you're never charged for an assumption.
No — the flat-rate quote holds unless new work is discovered and you approve it separately unless something new turns up and you sign off on it.
Gas and electric equipment are both covered equally.
We service whatever's already installed, regardless of who put it in.
Coverage extends through Tenaha and the nearby zips listed here.
Confirm My Coverage
